|
Scratch-proof your device with the exclusive, patented film - only available with the invisibleSHIELD. Exceptionally clear and virtually indestructible, you can show off your gadget and use it without fear of scratching.
The ultra-thin film is only 0.2 mm thick and will not add bulk to your device, so you can easily slip it into everything from charging docks to pockets and purses Nano-memory™ technology is visible as a very subtle texture in the surface of the film, and allows ZAGG to create precise, custom designs that hug the curves of your electronics and resists damage and scratches.
The Military Grade invisibleSHIELD film was originally developed for the U.S. Military to protect helicopter blades The Lifetime Replacement Warranty means you only need to buy once – if the invisibleSHIELD ever becomes damaged, ZAGG will replace it for the life of your device (Customers can register their ZAGG warranty card online, by fax or by mail).
The invisibleSHIELD gives your device increased grip, making it less likely to slide out of your hands and be dropped.
Over 1,000,000 sold
Q: How long after installing the invisibleSHIELD™ can I safely remove and reinstall it?
A: Within 3-5 minutes. If you do need to take the shield off for reinstallation, we suggest keeping your fingers wet and very carefully removing the shield (so you don't stretch it). After this, you can reapply it to the device as normal.
Q: My solution bottle came empty or leaked. How can I get more?
A: The SHIELDspray application solution is mostly a water-based solution, so if your bottle doesn't have solution in it, we suggest just filling it up with water. There is usually enough residue left in the bottle from the original solution, so just filling it up with water again should make it work just fine! If you run out during the installation, you can still refill the bottle up to 2-3 more times and still have the same effect.
Q: My shield won't stick on the corners. What do I do?
A: Leave your device (with the shield on it) alone for 10-15 minutes, and then try to stick it down. Waiting will allow the shield to dry and become more tacky. If it still doesn't stick, give it a few more minutes and try again. Repeat this process as needed.
Q: Some of these pieces are very small. How do I put them on?
A: While keeping your fingers moist, carefully pick up the SHIELD on an edge and lightly mist it before laying it down on the device. If these pieces become especially wet, they might not start to stick for a few minutes. If this does happen, please be patient in waiting for them to dry, and stick.
Q: When do I qualify for the Lifetime Replacement Policy?
A: The invisibleSHIELD™ is made of a very durable material that is difficult to scratch or scuff. The Lifetime Replacement Policy is for invisibleSHIELD™ products that have become damaged while protecting your device. We do not provide warranty for the device that your invisibleSHIELD™ is applied on, only for the invisibleSHIELD™ itself and we are not responsible for damages to your device.
Q: What should I do if I need to send my device to the manufacturer?
A: There are times when you may need to send in your electronic device to the manufacturer for warranty repair work. If this is the case, we recommend taking the invisibleSHIELD™ off of your device before sending it in for repair.
Once you remove the invisibleSHIELD™, email us at info@valueoutfitters.com and we will then be prepared for you to send it back to us
Upon receipt of your invisibleSHIELD™, you will be sent a new invisibleSHIELD, free of charge, per our free replacement policy. Please note that the free shipping option is only available for new orders. For replacement orders you will be charged a minimal fee of $3.95 ($5.95 for laptop shields) for shipping and handling. (Sending your original invisibleSHIELD™ back to our offices will keep your Lifetime Replacement Guarantee intact).
|
